Brocade FastIron Ethernet Switch Security Configuration Guide - Manual (Page 380)

Hit Count: (1Min) N/A (5Sec) N/A
(PktCnt) N/A (ByteCnt) 0
---------------------------------------------------------------
The following sample output shows an Ethernet interface that has a MAC filter applied and ACL
accounting enabled.
device#show access-list accounting ethernet 3/1/2 in
MAC Filters Accounting Information
0: DA ANY SA 0000.0000.0001 - MASK FFFF.FFFF.FFFF
action to take : DENY
Hit Count: (1Min) 0 (5Sec) 0
(PktCnt) 0 (ByteCnt) 0
-----------------------------------------------------------------
65535: Implicit Rule deny any any
Hit Count: (1Min) 5028 (5Sec) 2129
(PktCnt) 5028 (ByteCnt) 643584
------------------------------------------------------------------
History
Release version Command history
08.0.10 This command was introduced.
show ipv6 raguard
Displays the RA guard policy configuration.
Syntax show ipv6 raguard { name | all }
Parameters name
Displays the configuration of the specified RA guard policy.
all
Displays the configuration of all RA guard policies.
Modes Privileged EXEC
Examples The following example shows how to display the RA guard policy configurations:
Brocade#show ipv6 raguard all
policy:policy1
whitelist:1
max_pref:medium
policy:policy2
whitelist:0
show ipv6 raguard counts
Displays the RA guard drop or permit counts.
Syntax show ipv6 raguard counts { name | all }
Parameters name
show ipv6 raguard
380 FastIron Ethernet Switch Security Configuration Guide
53-1003088-03