Brocade FastIron Ethernet Switch Security Configuration Guide - Manual (Page 378)

Examples The output displayed will give information about IPv4 ACLs or IPv6 ACLs, or MAC filters based on the
configuration of the port or interface. If both IPv4 and IPv6 ACLs are configured on the same port, it will
give both IPv4 and IPv6 ACL accounting information in a single output.
The following sample output shows a virtual interface that has both IPv4 and IPv6 ACLs applied to the
same port and has ACL accounting enabled.
device#show access-list accounting ve 16 in
IPV4 ACL Accounting Information
devNum[0] => ACL: 10
0: permit any
Hit Count: (1Min) 0 (5Sec) 0
(PktCnt) 0 (ByteCnt) 0
----------------------------------------------------------------------
65535: Implicit Rule deny any any
Hit Count: (1Min) 0 (5Sec) 0
(PktCnt) 0 (ByteCnt) 0
----------------------------------------------------------------------
IPV6 ACL Accounting Information
devNum[0] => ACL: v6
0: permit ipv6 any any
Hit Count: (1Min) 0 (5Sec) 0
(PktCnt) 0 (ByteCnt) 0
-----------------------------------------------------------------------
65533: Implicit ND_NA Rule: permit any any
Hit Count: (1Min) 0 (5Sec) 0
(PktCnt) 0 (ByteCnt) 0
-----------------------------------------------------------------------
65534: Implicit ND_NS Rule: permit any any
Hit Count: (1Min) 0 (5Sec) 0
(PktCnt) 0 (ByteCnt) 0
----------------------------------------------------------------------
65535: Implicit Rule: deny any any
Hit Count: (1Min) 0 (5Sec) 0
(PktCnt) 0 (ByteCnt) 0
----------------------------------------------------------------------
Security Commands
378 FastIron Ethernet Switch Security Configuration Guide
53-1003088-03