Brocade FastIron Ethernet Switch Security Configuration Guide - Manual (Page 212)

default key mirabeau dot1x
device(config)#dot1x-enable e 1 to 3
device(config-dot1x)#re-authentication
device(config-dot1x)#timeout re-authperiod 2000
device(config-dot1x)#timeout quiet-period 30
device(config-dot1x)#timeout tx-period 60
device(config-dot1x)#maxreq 6
device(config-dot1x)#exit
device(config)#interface e 1
device(config-if-e1000-1)#dot1x port-control auto
device(config-if-e1000-1)#exit
device(config)#interface e 2
device(config-if-e1000-2)#dot1x port-control auto
device(config-if-e1000-2)#exit
device(config)#interface e 3
device(config-if-e1000-3)#dot1x port-control auto
device(config-if-e1000-3)#exit
Hub configuration
The following figure illustrates a configuration where three 802.1X-enabled Clients are connected to a
hub, which is connected to a port on the Brocade device. The configuration is similar to that in the
Sample point-to-point 802.1X configuration figure, except that 802.1X port security is enabled on only
one port, and the multiple-hosts command is used to allow multiple Clients on the port.
Hub configuration
212 FastIron Ethernet Switch Security Configuration Guide
53-1003088-03