Brocade FastIron Ethernet Switch Security Configuration Guide - Manual (Page 377)

show access-list accounting
Displays ACL accounting statistics
Displays ACL accounting statistics for IPv4 ACLs, IPv6 ACLs, and Layer 2 MAC filters.
Syntax show access-list accounting [ethernet | ve] num in
Parameters ethernet
Displays accounting statistics for an Ethernet interface.
ve
Displays accounting statistics for a virtual interface.
num
Specifies the ID of the Ethernet or virtual interface.
in
Used for incoming traffic.
Modes Privileged EXEC.
Command Output The show access-list accounting command displays the following information.
Output field Description
IPV4 ACL Accounting Information
or IPv6 ACL Accounting
Information Denotes the ACL for which the accounting information was collected.
devNum [#] => ACL: Num Specifies the device number and the ID of the ACL used.
# Shows the index of the ACL entry, starting with 0, followed by the permit or
deny condition defined for that ACL entry. (The first entry created for an ACL
is assigned the index 0. The next one created is indexed as 1, and so on.)
Hit count Shows the number of hits for each counter.
show access-list accounting
FastIron Ethernet Switch Security Configuration Guide 377
53-1003088-03