Brocade FastIron Ethernet Switch Security Configuration Guide - Manual (Page 238)

Field Description
Static Macs The number of currently connected active static hosts.
Static Conf The number of static hosts that are configured on the physical port.
Max Macs The maximum number of allowed MAC addresses.
Displaying the MAC-VLAN table for a specific MAC address
Enter the show table-mac-vlan command to display the MAC-VLAN table information for a specific
MAC address.
device(config)#show table-mac-vlan 0000.0010.1001
-------------------------------------------------------------------------------
MAC Address Port Vlan Authenticated Time Age dot1x
-------------------------------------------------------------------------------
0000.0010.1001 1/1/1 2 Yes 00d00h05m45s Ena Dis
Syntax: show table-mac-vlan mac-address
The following table describes the information in this output.
Field Description
MAC Address The MAC address for which this information is displayed.
Port The port where MAC-based VLAN is enabled.
Vlan The VLAN to which the MAC address has been assigned.
Authenticated Yes indicates authentication is successful.
No indicates authentication has failed.
Inp indicates authentication in progress
Rst indicates a restricted VLAN
Time The time at which the MAC address was authenticated. If the clock is set on the Brocade device,
then the actual date and time are displayed. If the clock has not been set, then the time is
displayed relative to when the device was last restarted.
Age The age of the MAC address entry in the authenticated MAC address list.
Dot1x Indicates if 802.1X authentication is enabled or disabled for the MAC address.
Displaying allowed MAC addresses
Enter the show table-mac-vlan allowed-mac command to display information about successfully
authenticated MAC addresses.
device#show table-mac-vlan allowed-mac
Displaying the MAC-VLAN table for a specific MAC address
238 FastIron Ethernet Switch Security Configuration Guide
53-1003088-03