Brocade FastIron Ethernet Switch Security Configuration Guide - Manual (Page 201)

Displaying 802.1X configuration information
To display information about the 802.1X configuration on the Brocade device, enter the show dot1x
command.
device#show dot1x
PAE Capability : Authenticator Only
system-auth-control : Enable
re-authentication : Disable
global-filter-strict-security : Enable
quiet-period : 60 Seconds
tx-period : 30 Seconds
supptimeout : 30 Seconds
servertimeout : 30 Seconds
maxreq : 2
reAuthMax : 2
re-authperiod : 3600 Seconds
Protocol Version : 1
Syntax: show dot1x
The following table describes the information displayed by the show dot1x command.
Output from the show dot1x command TABLE 15
Field Description
PAE Capability The Port Access Entity (PAE) role for the Brocade device. This is always
"Authenticator Only".
system-auth-control Whether system authentication control is enabled on the device. The dot1x-enable
command enables system authentication control on the device.
re-authentication Whether periodic re-authentication is enabled on the device. Refer to Configuring periodic
re-authentication on page 192.
When periodic re-authentication is enabled, the device automatically
re-authenticates Clients every 3,600 seconds by default.
global-filter-strict-
security Whether strict security mode is enabled or disabled globally. Refer to Disabling and
enabling strict security mode for dynamic filter assignment on page 188.
quiet-period When the Brocade device is unable to authenticate a Client, the amount of time the
Brocade device waits before trying again (default 60 seconds). Refer to
Setting the quiet
period on page 193.
tx-period When a Client does not send back an EAP-response/identity frame, the amount of time
the Brocade device waits before retransmitting the EAP-request/identity frame to a Client
(default 30 seconds). Refer to
Setting the wait interval for EAP frame retransmissions on
page 193.
supptimeout When a Client does not respond to an EAP-request frame, the amount of time before the
Brocade device retransmits the frame. Refer to "
Setting the wait interval for EAP frame
retransmissions on page 193.
Displaying 802.1X configuration information
FastIron Ethernet Switch Security Configuration Guide 201
53-1003088-03