Brocade FastIron Ethernet Switch Security Configuration Guide - Manual (Page 303)

The following shows an example Syslog message and SNMP trap message related to passcode
authentication.
New passcode: 01234567. Expires in 1440 minutes. Old passcode is valid for another 5
minutes.
To disable Syslog messages for passcodes, enter the no auth-mode passcode log syslog command.
device(config-vlan-10-webauth)# no auth-mode passcode log syslog
Enter the following command to disable SNMP trap messages for passcodes.
device(config-vlan-10-webauth)# no auth-mode passcode log snmp-trap
Enter the following command to re-enable Syslog messages for passcodes after they have been
disabled.
device(config-vlan-10-webauth)# auth-mode passcode log syslog
Enter the following command to re-enable SNMP trap messages for passcodes after they have been
disabled.
device(config-vlan-10-webauth)# auth-mode passcode log snmp-trap
Syntax: [no] auth-mode passcode log [ syslog | snmp-trap ]
Re-sending the passcode log message
If passcode logging is enabled, you can enter a CLI command to retransmit the current passcode to a
Syslog message or SNMP trap. To do so, enter the auth-mode passcode resend-log command.
device(config-vlan-10-webauth)# auth-mode passcode resend-log
Syntax: auth-mode passcode resend-log
NOTE
The switch retransmits the current passcode only. Passcodes that are in the grace period are not sent.
Manually refreshing the passcode
You can manually refresh the passcode instead of waiting for the system to automatically generate one.
When manually refreshed, the old passcode will no longer work, even if a grace period is configured.
Also, if the passcode refresh method duration of time is used, the duration counter is reset when the
passcode is manually refreshed. The passcode refresh method time of day is not affected when the
passcode is manually refreshed.
To immediately refresh the passcode, enter the auth-mode passcode generate command.
device(config-vlan-10-webauth)# auth-mode passcode generate
Syntax: auth-mode passcode generate
Re-sending the passcode log message
FastIron Ethernet Switch Security Configuration Guide 303
53-1003088-03