Brocade FastIron Ethernet Switch Security Configuration Guide - Manual (Page 374)

mac filter enable-accounting
Configures ACL accounting for MAC filters.
Enables ACL accounting on Layer 2 MAC filters.
The no form disables ACL accounting on Layer 2 MAC filters.
Syntax mac filter num enable-accounting
no mac filter num enable-accounting
Command Default This option is disabled.
Parameters num
Specifies the MAC filter ID.
enable-accounting
Enables MAC filter accounting on the specified interface.
Modes Global configuration.
Usage Guidelines The no form of this command disables ACL accounting on the associated Layer 2 MAC filter interface.
Examples The following example shows how to enable ACL accounting on a Layer 2 MAC filter.
device(config)# mac filter 1 permit 0000.0000.0001 ffff.ffff.ffff any
device(config)# mac filter 1 enable-accounting
device(config)# interface ethernet 3/21
device(config-if-e1000-3/21)# mac filter-group 1
History
Release version Command history
08.0.10 This command was introduced.
preference-maximum
Configures an RA guard policy to accept RAs of a specified router preference. The no form of this
command removes the router preference for an RA guard policy.
Syntax preference-maximum { high | low | medium }
no preference-maximum { high | low | medium }
Parameters high
Sets the router preference of RAs for the RA guard policy as high (allows all RAs). This is
the default.
low
Allows RAs of low router preference .
medium
mac filter enable-accounting
374 FastIron Ethernet Switch Security Configuration Guide
53-1003088-03