Brocade FastIron Ethernet Switch Security Configuration Guide - Manual (Page 372)

RA packets drop due to congestion if they are received at the line rate. For less load on the CPU,
logging can be disabled on the RA guard policy.
Examples The following example shows how to enable logging on an RA guard policy:
Brocade(config)# ipv6 raguard policy p1
Brocade(config-ipv6-RAG-policy p1)# logging
ipv6 raguard policy
Configures the specified RA guard policy and enters RA guard policy configuration mode. The no form
of this command removes the specified RA guard policy.
Syntax ipv6 raguard policy name
no ipv6 raguard policy name
Parameters name
An ASCII string indicating the name of the RA guard policy to configure.
Modes Global configuration
Usage Guidelines You can configure up to 256 RA guard policies.
Examples The following example shows how to configure an RA guard policy and enter RA guard policy
configuration mode:
Brocade(config)# ipv6 raguard policy policy1
Brocade(ipv6-RAG-policy policy1)#
ipv6 raguard vlan
Associates the RA guard policy on a VLAN. The no form of the command dissociates the RA guard
policy from the VLAN.
Syntax ipv6 raguard vlan number policy name
no ipv6 raguard vlan number policy name
Parameters number
ID number of the VLAN to which the specified RA guard policy should be associated. Valid
range is from 1 to 4095.
policy name
Associates the RA guard policy with the specified by the name to the VLAN.
Modes Global configuration
ipv6 raguard policy
372 FastIron Ethernet Switch Security Configuration Guide
53-1003088-03