Brocade FastIron Ethernet Switch Security Configuration Guide - Manual (Page 237)

NOTE
If static Mac-Based VLAN is configured on a port, the port will be added only to the VLAN table for
which the static MAC-based VLAN configuration exists.
NOTE
If the Dynamic MAC-based VLAN is enabled after any MAC-based VLAN sessions are established, all
sessions are flushed and the mac-vlan-permit ports are removed from the VLAN. The ports are then
added back to the VLAN dynamically after they successfully pass the RADIUS authentication process.
Configuring MAC-based VLANs using SNMP
Several MIB objects have been developed to allow the configuration of MAC-based VLANs using
SNMP. For more information, refer to the Unified IP MIB Reference Guide.
Displaying Information about MAC-based VLANs
This section describes the show commands that display information related to MAC-based VLANs.
Displaying the MAC-VLAN table
Enter the following command to display the MAC-VLAN table.
device(config)#show table-mac-vlan
----------------------------------------------------------------
Port Vlan Accepted Rejected Attempted Static Static Max
Macs Macs Macs Macs Conf Macs
----------------------------------------------------------------
1/1/1 N/A 1 1 0 0 1 10
Syntax: show table-mac-vlan
The following table describes the information in this output.
Field Description
Port The port number where MAC-based VLAN is enabled.
Vlan Not applicable for this feature, will always display n/a.
Accepted Macs The number of MAC addresses that have been successfully authenticated (dynamic hosts)
combined with the number of active static MAC addresses (static hosts).
Rejected Macs The number of MAC addresses for which authentication has failed for dynamic hosts.
Attempted Macs The number of attempts made to authenticate MAC addresses.
Configuring MAC-based VLANs using SNMP
FastIron Ethernet Switch Security Configuration Guide 237
53-1003088-03