Brocade FastIron Ethernet Switch Security Configuration Guide - Manual (Page 243)

0d18h46m28s:I:running-config was changed from console
0d02h12m25s:A:MAC Based Vlan Mapping failed for [0000.0011.0108 ] on port 0/2/1
(Invalid User)
0d02h08m52s:A:MAC Based Vlan Mapping failed for [0000.0011.011b ] on port 0/2/1
(Invalid User)
0d02h05m01s:A:MAC Based Vlan Mapping failed for [0000.0011.00df ] on port 0/2/1
(Invalid User)
0d02h01m15s:A:MAC Based Vlan Mapping failed for [0000.0011.0108 ] on port 0/2/1
(Invalid User)
0d02h01m15s:A:MAC Based Vlan Mapping failed for [0000.0011.0107 ] on port 0/2/1
(Invalid User)
0d01h58m43s:N:MAC Based Vlan Enabled on port 0/2/1
0d01h58m32s:N:MAC Based Vlan Disabled on port 0/2/1
0d01h39m00s:I:running-config was changed from console
0d01h38m28s:I:System: Interface ethernet 0/1/47, state up
0d01h38m27s:I:System: Interface ethernet 0/1/46, state up
0d01h38m27s:I:System: Interface ethernet 0/1/34, state up
0d01h38m27s:I:System: Interface ethernet 0/1/25, state up
Clearing MAC-VLAN information
Enter the clear table-mac-vlan interface command to clear MAC-VLAN information. Add the interface
id to clear information for a specific interface.
device#clear table-mac-vlan
interface
Sample MAC-based VLAN application
The following figure illustrates a sample configuration that uses MAC-based VLAN on port e 0/1/1 on
the Brocade device. In this configuration, three host PCs are connected to port e 0/1/1 through a hub.
Host A MAC address is statically configured on port e 0/1/1. The profile for Host B MAC address on the
RADIUS server specifies that the PC should be assigned to VLAN 2. Host C profile does not exist in the
RADIUS server, and will be put into a restricted VLAN.
Clearing MAC-VLAN information
FastIron Ethernet Switch Security Configuration Guide 243
53-1003088-03