Yokogawa Integral Oxygen Analyzer ZR202 - Manual (Page 127)

IM 11M13A01-04E 10-9
10. Other Functions
10.3 Initialization Procedure
Follow the table below to initialize parameters. The password for initialization is 1255.
Table 10.5 Initialization Procedure
Switch operation Display Description
> ٙ ENT
F 3 0
>
ٙ ENT
0 000
> ٙ ENT
1 000
> ٙ ENT
1 0 00
> ٙ ENT
1 2 00
>
ٙ ENT
12 0 0
> ٙ ENT
12 5 0
> ٙ ENT
125 0
> ٙ ENT
125 5
> ٙ ENT
1255
> ٙ ENT
USr Go
> ٙ ENT
USr Go
> ٙ ENT
F 30
T10.5E.EPS
Enter the parameter code for the item to be initialized.
The following show an example of entering "
F30. "
(Previous needed operations are omitted.)
Touch the [ ENT ] key to switch to the password entry display.
Enter the password 1255 for initialization.
After you enter the password and then touch the [ ENT ] key, all the digits flash.
Usr Go Touch the [ ENT ] key again to display " USER GO. "
The symbol ( ) indicates that the key is being touched.
Light characters indicate that the digits are flashing.
Usr Go Touch the [ ENT ] key once more.
All the digits then flash for two to three seconds, and data initialization starts.
The initialization is complete, and the parameter code selection display
then appears.
WARNING
• Do not attempt to turn off the equipment power during initialization (while “USR GO”
is flashing).