Yokogawa Integral Oxygen Analyzer ZR202 - Manual (Page 100)

IM 11M13A01-04E 8-12
8.5.3 Default Values
When the analyzer is delivered, or if data are initialized, output contacts are by default
as shown in Table 8.11.
Table 8.11 Output Contact Default Settings
Item Output contact 1 Output contact 2
High-high-limit alarm
High-limit alarm
Low-limit alarm
Low-low-limit alarm
Error
᭺
Warm-up ᭺
Output range change
Calibration
Maintenance
᭺
High-limit temperature alarm
Calibration-gas pressure drop
Unburnt gas detection
Operating contact status
Open Closed (fixed)
᭺ : Present T8.11E.EPS
Note
The above blank boxes indicate the items have been set off.