Teledyne LeCroy WaveRunner Automation Command - Manual (Page 451)

Automation Command and Query Reference Manual - Processor Reference
IncludeVirtualEdges Bool
When this control is set to true (default is false), the TIE values the result at the output have "virtual
edges" included in the output (i.e. values which are linearly interpolated) corresponding to edges which
did NOT transit. This allows a relatively uniform in time strm of values. This feature is mostly obviated
by the processor "ParamUpSample"
Description
IntervalsEdgeEdge Integer
From 1 to 100000 step 1 Range
For edge-edge methodology, this control sets the number of UI ( unit intervals) between edges to be
analyzed.
Description
IntervalType Enum
Timing Analysis can either performed using the edge-edge timing methodology (as was developed for
Time-Interval-Analyzers", or edge-ref, as is common for real-time oscilloscopes. Edge-Ref is highly
recommended.
Description
Values
EDGEEDGE
EDGEREF
LevelType Enum
Values
Absolute
Percent
PercentGNDMax
PercentGNDMin
PercentPkPk
MaxComboIntervals Integer
From 1 to 20000 step 1 Range
PercentLevel Double
From 0 to 100 step 1 Range
PermitGTHalfUI Bool
PLL1TransportDelay Double
From 0 to 1 step 1e-015 Range
PLLCompensateForMissingEdges Bool
2-120
918500 RevA