Teledyne LeCroy WaveRunner Automation Command - Manual (Page 287)

Automation Command and Query Reference Manual - Control Reference
MaskTestOn Bool
MaskType Enum
Values
bitrate10Mbps
bitrate2p5Mbps
bitrate5Mbps
Persist3DQuality Enum
This control only has an effect when Persisted is true and Persistence3D is true. It controls whether
the 3D view is shown as a wire frame (which can be monochrome or color graded), a solid (also can
be monochrome or color graded), or a shaded solid (always monochrome). For WireFrame or Solid,
if monochrome the brightness increases with height; if color graded the color changes from puple to
red with height. "Shaded" present the solid as if it were lit from the upper left.
Description
Values
Shaded
Solid
WireFrame
Persisted Bool
Sets/Queries the persisted state of the waveform. If the Display.LockPersistence control is set to
'AllLocked' then the persisted state of all displayed waveforms will be the same. If the
Display.LockPersistence control is set to 'PerTrace' then the persisted state of each waveform may be
independently controlled.
Description
Persistence3d Bool
Changes the persistence map from a two-dimensional surface with brightness or color indicating the
third dimension, to a perspective rendering of a three dimensional object, where the third dimension is
shown as height above the surface formed by points which are not lit. In 3d, that surface is same
color or brightness as points with one or very few hits so that the surface is visible; but that means
points with one or very few hits cannot be distinguished from the background. See also
Persist3DQuality, which controls the appearance of the 3D object.
Description
PersistenceMonoChrome Bool
When this control is false (the default state), persistence is color graded. When this control is set to
true, persistence is monochrome, in the color of the trace, and increasing number of hits is shown as
increasing brightness. This control only has an effect when Persisted is true.
Description
1-279
918500 RevA