Teledyne LeCroy WaveRunner Automation Command - Manual (Page 152)

Automation Command and Query Reference Manual - Control Reference
HelpMarkers Enum
Sets/Queries the level of detail for help markers (if indeed any of the selected parameter definitions
have help markers).
These markers are displayed on the source traces, and only if those traces are viewed simultaneously
with the parameter measurements.
Note: this setting is global for all Px
Description
Values
Detailed Detailed help markers
Off No help markers
Simple Simple help markers
HistoOn Bool
Sets/Queries the visibility of the histicons of the parameters which are viewed.
Description
MeasureSet Enum
Defines the mode in which the measurement system is working.
Description
Values
MyMeasure Custom list, each chosen from the list of available measurements.
StdHorizontal Standard Horizontal Measurements
StdVertical Standard Vertical Measurements
SetGateToDefault Action
Sets the measure gate to its default state. Valid only when in either Std. Vertical or Std. Horizontal
measurement modes. For MyMeasure see the equivalent controls under Px.
Description
ShowAllHelpMarkers Action
Force all 'HelpMarkers' on.
(HelpMarkers are the on-trace annotation of measurement setup and results)
Description
ShowMeasure Bool
Defines whether the measure results table is displayed or not.
Description
StatsOn Bool
Sets/Queries the visibility of parameter statistics. Note: the statistics are accumulated whether the
view of them is on or not, so you needn't have StatsOn = "On" to collect statistics.
Description
1-144
918500 RevA