IAI America ISWA User Manual
Page 59
51
1
1. Procedure for Motor Replacement
(3) Aligning Slider
An adjustment of the slider position is performed by putting a spacer (a jig or a block gauge) with the
VSHFL¿HGWKLFNQHVVEHWZHHQWKHPHFKDQLFDOHQGRQWKHKRPHVLGHDQGWKHVOLGHUWKHQSXVKLQJWKH
slider until there is no gap.
)RU,63:$6W\SHSXWDVSDFHUZLWKWKHVSHFL¿HGWKLFNQHVVDIWHUWKHFRYHULVUHPRYHG
For an actuator equipped with a brake, turn on the power supply to the controller and release the
brake to move the slider.
After moving the slider, deactivate the brake release, turn off the power to the controller and
disconnect the brake lead line connector.
The thickness of the spacer will differ according to the home offset distance, the SE (stroke end) to
ME (mechanical end) distance and the actuator type. (See Page 58.)
Spacer
Refer to Table 1 on page 58 for the
thickness of the spacer