IAI America ISWA - Manual (Page 16)

8
Precautions in Handling
1. Do not establish the speed or acceleration/deceleration settings beyond
the rated values.
Please do not establish the speed or acceleration/deceleration settings beyond the rated values. It may
cause an occurrence of vibration, malfunction, or shorten the product life.
When having the actuator run to synchronize the multi axes, adjust the speed setting to the axis with
the maximum speed and the acceleration/deceleration to the axis with the minimum acceleration/
deceleration.
Setting especially the acceleration/deceleration beyond the rated values may cause a creep or a slip of
the coupling.
2. Set the allowable load moment within the allowable range.
Make sure to set the allowable load moment within the allowable range. If a load beyond the range is
applied, it may shorten the product life. An extremely high load may cause breakdown.
3. Set the overhang length within the allowable range.
Make sure to set the overhang length within the allowable range. The overhang length beyond the
allowable range may cause vibration or abnormal noise.
4. Use the product with the duty below 50%.
Please use the product with the duty below 50%. A use with duty that exceeds 50% may cause overload or
generate heat on motor. If the duty is extremely high, it may cause the motor to be damaged.
Duty (%) = (Continuous Operation / (Continuous Operation + Stop Duration)) / 100
CAUTION: If an overload error occurs even with the duty less than 50%, try to either extend the
stop duration to lower the duty or lower the acceleration/deceleration speed.