IAI America ISWA - Manual (Page 17)

9
5. Moving the actuator back and forth in a short distance may cause wear
of grease.
Continuous back and forth operation within a distance less than 30mm may cause wear of grease.
Using the product with the actuator not being certainly retained or affixed may cause abnormal noise,
vibration, malfunction or shorten the product life.
It is recommended to have 5 rounds of back and forth operation in a distance more than 50mm after
every 5,000 to 10,000 rounds of the short distance operation. A layer of the grease will recover.
7. Transportation
6. Make sure to attach the actuator properly by following this instruction manual.
7.1 Handling of Single Axis Type
Exercise precaution to the following when transporting an actuator by itself.
7.1.1 Handling the Packed Unit
Do not damage or drop. The package is not supplied with any special treatment that enables it to
resist an impact caused by a drop or crash.
The operator should not carry heavy shipping boxes by themselves. Consider an appropriate method
for transportation.
If the package is to be left standing, it should be in a horizontal position. Follow the instruction if there
is any for the packaging condition.
Do not climb on top of the package.
Do not put any load that may cause a deformation or breakage of the package.
7.1.2 Handling of Unpackaged Product
Do not carry the actuator by holding the cable, or do not move it by pulling the cable.
Hold the body base when transporting the actuator.
When carrying the actuator, exercise caution not to bump it against nearby objects or structures.
Do not exert an excessive force on any part of the actuator.