Fairbanks NexWeigh - Manual (Page 77)

Appendix II: Ecolab Sanitation
04/14 77 51216 -- Rev. 6
B. SANITATION PROCEDURES, CONTINUED
8. Rinse all surfaces and scale platform.
─ Move the hose stream from side-to-side, starting at the top and working to the
bottom.
9. Remove the Platform Lift and set it aside.
10. Unscrew all the Rubber Stops.
11. Hand-scrub the Scale Pillar, Bottom, Platform Lift,
and Stops with HC-10 Solution, and then rinse the
parts completely.
12. Carefully tip the scale back or lay it on its side.
─ Always ask for help in doing this, if needed.
13. Pre-rinse, and then hand brush the scale with HC-10 Detergent Solution.
14. Hand Brush the bottom of the unit, cleaning it with HC-10 Detergent Solution,
rinsing thoroughly.
15. Inspect all the scale parts completely, correcting any discrepancies found.
─ List any damaged replacement parts to be ordered, as needed.
16. Re-assemble all the cleaned and rinsed scale parts, replacing the scale back into
its proper position.
17. Prepare the entire area for production use, then inspect it as an “outside
observer” for cleanliness and correct placement of all the operation elements.
18. Notify the supervisor for an inspection of the completed work.
─ Report to him or her of any needed replacement parts.