Fairbanks NexWeigh - Manual (Page 29)

Section 4: Programming Configuration
04/14 29 51216 -- Rev. 6
4.5.2. Configuration Menu, Continued
tArE:
Programming the tare setting: (the means by which a container’s weight
may be removed, to set the instrument to display the net weight only) The display
will indicate
tArE followed by the current tare setting. Press
OVER/UNDER/NEXT , UNITS or TARE to change the selection. Press
PROGRAM/ENTER to enter the selection. Available selections are:
OFF Tare is disabled.
ON Tare is active.
On-CLr Tare automatically clears when Gross weight returns to Zero.
* Underline identifies the program default
HL:
Overload limit: The actual value at which the display goes to OL (represented
as a percentage of capacity). The display will indicate HL followed by the current
setting. Press OVER/UNDER/NEXT or UNITS to scroll up, or TARE to scroll
down through the available choices. Press PROGRAM/ENTER to enter the
selection. Available selections are:
102.5 103 105 110 300
UL: U nderload L imit: The actual value at which the display goes to UL
(represented as a percentage of capacity behind zero). The display will indicate UL
followed by the current setting. Press OVER/UNDER/NEXT or UNITS to scroll
up, or TARE to scroll down through the available choices. Press
PROGRAM/ENTER to enter the selection. Available selections are:
5.5 10 25 50 100