Fairbanks NexWeigh - Manual (Page 22)

Section 4: Programming Configuration
04/14 22 51216 -- Rev. 6
4.5.1. Setup Menu, Continued
Port 1:
Programming Port 1: The display will indicate Port 1, then OutPut , then
the current setting. Press OVER/UNDER/NEXT , UNITS or TARE to scroll
through the available choices. Press PROGRAM/ENTER to enter the correct
selection. Available selections are listed below.
OFF Function is not active.
PoLL Computer demand mode.
PoLLid Computer demand mode with ID
Contin Continuous output.
button Transmit when PRINT is pressed.
Auto Transmit occurs when Autoprint threshold is met or exceeded.
diS Continuous output using remote display format.
* Underline identifies the program default
bAud:
Programming Port 1 baud rate: The display will indicate bAud then the
current setting. Press OVER/UNDER/NEXT or UNITS to scroll up, or TARE to
scroll down through the available choices. Press PROGRAM/ENTER to enter the
selection. Available selections are:
300 600 1200 2400 4800
9600 19200 38400 57600 115200
dbit:
Programming Port 1 data bits: The display will indicate dbit X where X is
either 7 or 8 . Press OVER/UNDER/NEXT , UNITS , or TARE to select proper
value. Press PROGRAM/ENTER to enter proper selection.
P:
Programming Port 1 Parity setting: The display will indicate P along with the current
setting. Press OVER/UNDER/NEXT , UNITS or TARE to change the selection.
Press PROGRAM/ENTER to enter the selection. Available selections are:
P nonE P odd P EvEn
buSY:
Programming Port 1 handshaking: The display will indicate XXbuSY ,
where XX is either no , Lo , or Hi . Press OVER/UNDER/NEXT , UNITS or
TARE to change the selection. Press PROGRAM/ENTER to enter the selection.