Fairbanks NexWeigh - Manual (Page 54)

Section 5: Serial I/O
04/14 54 51216 -- Rev. 6
5.4.8. NexWeigh Serial Commands and Definitions,
Continued
kk) Set Date
Definition: Used to set the date in the RTC.
Command: SDA
Options: mm/dd/yy
Sample Command: "SDA 05/28/99\r"
ll) Set Security Level
Definition: Used to set the scale’s security level. Only valid levels between 0 and
MAXSECURITYLEVEL allowed. This can be a dangerous command. One could
cause themselves to be locked out from further commands.
Command: ‘SSL’ ‘level’
Options: 0-5
Sample Command: "SSL 1\r"
mm) Set Capacity
Definition: Used to set the scale’s capacity in Primary units.
Command: ‘STC’ ‘value’
Options: decimal weight value
Sample Command: "STC 100 \r"
nn) Set Test Weight
Definition: Used to set the scale’s test weight value in Primary units.
Command: ‘STW’ ‘value’
Options: decimal weight value
Sample Command: "STW 75.5 \r"
oo) Set Accumulate Enable
Definition: Used to set the Accumulate enable parameter for the scale.
Command: ‘SAC’ ‘mode’
Options: E,D
Sample Command: "SAC E\r"
pp) Set Output ID Enable
Definition: Used to set the Output Scale Id enable parameter for the scales serial
output stream.
Command: ‘SOI’ ‘mode’
Options: E,D
Sample Command: "SOI E\r"