Fairbanks NexWeigh - Manual (Page 48)

Section 5: Serial I/O
04/14 48 51216 -- Rev. 6
5.4.8. NexWeigh Serial Commands and Definitions,
Continued
f) Gross mode
Definition: Used to switch scale to gross mode
Command: ‘G’
Options: none
Sample Command: "G \r"
g) Gross or Net mode
Definition: Used to toggle scale between gross and net mode
Command: ‘GN’
Options: none
Sample Command: "GN \r"
h) Set AZT band
Definition: Used to set the Auto zero tracking band. Only valid settings allowed.
Command: ‘SAT’ ‘divisions’
Options: 0.5, 1, 3, 0
Sample Command: "SAT 0.5\r"
Sample Command: "SAT 3\r"
i) Set Scale Id
Definition: Used to set the scale’s id field. Only valid ids between MINSCALEID and
MAXSCALEID allowed.
Command: ‘SSI’ ‘ID’
Options: 1-32
Sample Command: "SSI 25\r"
j) Set Output Mode
Definition: Used to set the serial output mode on the RS232 port. Polled, Polled w/id,
Continuous, Printer, Auto Printer, Remote display.
Command: ‘som’ ‘mode’
Options: POLL, POLLID, CONT, PRTR, APRT, REMD
Sample Command: "som POLL\r"