Fairbanks NexWeigh - Manual (Page 28)

Section 4: Programming Configuration
04/14 28 51216 -- Rev. 6
4.5.2. Configuration Menu, Continued
O.r:
Programming the zero range: (the percentage of scale capacity that may be
removed by pressing the Zero Key). The display will indicate O.r X where X is the
current setting. Press OVER/UNDER/NEXT , UNITS or TARE to change the
selection. Press PROGRAM/ENTER to enter the selection. Available selections
are:
100 100 percent zero range
2 2 percent zero range
d:
Programming the division size: The display will indicate d followed by the
current division size setting. Press OVER/UNDER/NEXT or UNITS to scroll up,
or TARE to scroll down through the available choices. Press
PROGRAM/ENTER to enter the selection. Available selections are:
50 20 10 5 2 1
0.5 0.2 0.1 0.05 0.02 0.01
0.005 0.002 0.001 0.0005 0.0002 0.0001
FiLtEr:
Programming the filter setting: (intended to minimize the effects of
motion, vibration, and wind currents) The display will indicate FiLtEr followed by the
current filter setting. Press OVER/UNDER/NEXT or UNITS to scroll up, or
TARE to scroll down through the available choices. Press PROGRAM/ENTER
to enter the selection. Available selections are:
1 3 5 11 15 20 30 50
FLF:
Flush filter factor: Allows instrument to switch to fast filter rate if weight
change exceeds the number of divisions in setting. The display will indicate FLF
followed by the current setting. Press OVER/UNDER/NEXT or UNITS to scroll
up, or TARE to scroll down through the available choices. Press
PROGRAM/ENTER to enter the selection. Available selections are:
oFF 1 2 5 10 20 50 100