Fairbanks NexWeigh - Manual (Page 71)

Section 6: Operations
04/14 71 51216 -- Rev. 6
6.3.7. Check Weighing, Continued
7. Press OVER/UNDER/NEXT to toggle between nEt n, (Checkweigh in
gross mode) or nEt Y, (Checkweigh in net mode).
8. Press PROGRAM/ENTER to display diS Y, or diS n. This will determine
whether the numeric display is active or not while Checkweighing is active.
9. Press OVER/UNDER/NEXT to toggle between diS Y, and diS n.
Note: If weighing in net mode and numeric display is active, the instrument can
accidentally be placed in the GROSS mode and the display then might not match
the Checkweigh indication.
10. With the desired selection displayed, press PROGRAM/ENTER to display
UnitS With UnitS displayed, one of the units legends will be lit. This is the
weigh units the Checkweigh limits will be defined by in the following steps.
11. Press OVER/UNDER/NEXT to scroll through the choices, including custom
units.
12. With the desired units legend lit, press PROGRAM/ENTER to display
hAnd Y, or hAnd n. This determines the method for defining the acceptance
band. Using hAnd Y provides the user the ability to enter all ranges manually,
whereby hAnd n provides the user the ability to use a sample weight for the
accept target range.
13. Press OVER/UNDER/NEXT to toggle between the two choices.
14. With the desired selection displayed, press PROGRAM/ENTER .
If hAnd Y is selected, go to step 21.
15. If hAnd n is selected, the instrument will display live weight along with
scrolling under, accept, and over instruments. The instrument is waiting for an
acceptance range weight to be applied. Apply a sample weight of an
acceptable value and press
PROGRAM/ENTER . This weight will be used
to assist defining the start of accept and end of accept values.