Fairbanks NexWeigh - Manual (Page 30)

Section 4: Programming Configuration
04/14 30 51216 -- Rev. 6
4.5.2. Configuration Menu, Continued
d rAtE:
Programming the display update rate: The times between display
updates in seconds. The display will indicate d rAtE and then the current setting.
Press OVER/UNDER/NEXT or UNITS to scroll up, or TARE to scroll down
through the available choices. Press PROGRAM/ENTER to enter the selection.
Available selections are:
0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8
0.9 1.0
P1:
Output format of Port1, GTN or net only: This determines whether the output
from Port1 will be transmitted as a net weight only or a gross/tare/net weighment.
The display will indicate
P1 followed by the current setting. Press
OVER/UNDER/NEXT , UNITS or TARE to change the selection. Press
PROGRAM/ENTER to enter the selection. Available choices are:
Gtn nEt
P2:
Output format of Port2 , GTN or net only : This determines whether the
output from Port2 will be transmitted as a net weight only or a gross/tare/net
weighment. The display will indicate
P1 followed by the current setting. Press
OVER/UNDER/NEXT , UNITS or TARE to change the selection. Press
PROGRAM/ENTER to enter the selection. Available choices are:
Gtn nEt
The NexWeigh instrument will now return to the ConFiG prompt. Navigate to the
desired menu heading to continue programming, or to DONE to finish.