App menu, X.xxupd, A thld – Fairbanks NexWeigh User Manual
Page 31
Section 4: Programming Configuration
04/14
31
51216 -- Rev. 6
4.5.3. APP Menu
7. Press and hold the
PROGRAM/ENTER
key or press
S1
on the main PCB to
display
SEtUP
.
8. Press
UNITS
or
OVER/UNDER/NEXT
twice to display
APP
.
9. Press the
PROGRAM/ENTER
key to enter
APP
menu.
X.XXuPd:
Display microvolts per division: This is a reference to display the
current microvolts per division. The display will indicate X.XXuPd where X.XX is a
numeric value of the microvolts per division. Press any front panel pushbutton other
than
B/G / NET
to continue.
4-20:
4-20mA analog output setting: Enables or disables the output. The display
will indicate 4-20 followed by the current setting of
Y
for enable and
N
for disable.
Press
OVER/UNDER/NEXT
,
UNITS
or
TARE
to change the selection. Press
PROGRAM/ENTER
to enter the selection.
ACC:
Accumulate feature enabled: Enables or disables the accumulate feature.
The display will indicate
ACC
followed by the current setting of
Y
for enable and
N
for disable. Press
OVER/UNDER/NEXT
,
UNITS
or
TARE
to change the
selection. Press
PROGRAM/ENTER
to enter the selection.
A thLd:
Autoprint and accumulate threshold: This is the number of divisions the
instrument must meet or exceed for an autoprint or an auto-accumulation to occur.
The display will indicate
A thld
, followed by the current setting in divisions with the
left digit flashing. Press
UNITS
to increase the digit, press the
1
key to decrease
the flashing digit. Press
OVER/UNDER/NEXT
to move the flashing digit to the
right or press the
TARE
to move it to the left. Press
PROGRAM/ENTER
when
the display shows the correct threshold setting. The acceptable range is 1 to 1000
and default value is
10
divisions.