Fairbanks NexWeigh - Manual (Page 43)

Section 5: Serial I/O
04/14 43 51216 -- Rev. 6
SEL
EXIT
POWER
SHIFT
ALARM
LF
GROUP
Micro Feed
Down
FF/LOAD
Micro Feed
Up
ITEM
MENU
TEAR
SET
PARK
PRINT
QUIET
TOF
SEL
MENU
5.4.5. Okidata 420 Form Printer
The NexWeigh should be programmed for Port 1 Output button, 9600 baud, 8 data
bits, no stop bits, and Hibusy.
To change Menu Settings:
1. To enter MENU MODE, press and hold the SHIFT key while pressing the SELECT
key. The “MENU” legend will be illuminated while in the menu mode.
2. With the printer in the Menu Mode, press PRINT to print the complete menu. The
current default settings print out. It is recommended to use tractor fed paper.
NOTE: The printed menu selections are different for each emulation mode.
3. Press GROUP to select the relevant group that needs to be changed (the group is
the left-hand column on the Menu printout).
4. Press ITEM to select the relevant item within the selected group (the Item is the
center column on the Menu printout).
5. Press SET to cycle through the settings available for the item you want to change
(the settings are the right-hand column on the Menu printout).
6. Press and hold the SHIFT key while pressing the SELECT key exit the Menu
Mode.
Note: If you turn off the printer before exiting the menu mode, any changes will be
lost.