Setup menu, continued baud, Dbit, Opti – Fairbanks NexWeigh User Manual
Page 24: Opda, Opid
Section 4: Programming Configuration
04/14
24
51216 -- Rev. 6
4.5.1. Setup Menu, Continued
bAud:
Programming Port 2 baud rate: The display will indicate
bAud
then the
current setting. Press
OVER/UNDER/NEXT
or
UNITS
to scroll up, or
TARE
to
scroll down through the available choices. Press
PROGRAM/ENTER
to enter the
selection. Available selections are:
300
600
1200
2400
4800
9600
19200
38400
57600
115200
dbit:
Programming Port 2 data bits: The display will indicate
dbit X
where
X
is
either
7
or
8
. Press
OVER/UNDER/NEXT
,
UNITS
, or
TARE
to select proper
value. Press
PROGRAM/ENTER
to enter proper selection.
P:
Programming Port 2 Parity setting: The display will indicate
P
along with the current
setting. Press
OVER/UNDER/NEXT
,
UNITS
or
TARE
to change the selection.
Press
PROGRAM/ENTER
to enter the selection. Available selections are:
P nonE
P odd
P EvEn
oPti:
Include time data with transmitted data: This determines whether or not to
include the time in the data string for Port 2. Display will indicate
oPti
followed by
the current selection of
Y
for yes to include, or n for no to exclude. Press
OVER/UNDER/NEXT
,
UNITS
or
TARE
to change the selection. Press
PROGRAM/ENTER
to enter the selection.
oPdA:
Include date data with transmitted data: This determines whether or not to
include the date in the data string for Port 2. Display will indicate
oPdA
followed by
the current selection of
Y
for yes to include, or n for no to exclude. Press
OVER/UNDER/NEXT
,
UNITS
or
TARE
to change the selection. Press
PROGRAM/ENTER
to enter the selection.
oPId:
Include ID data with transmitted data: This determines whether or not to
include the ID in the data string for Port 2. Display will indicate
oPId
followed by the
current selection of
Y
for yes to include, or
n
for no to exclude. Press
OVER/UNDER/NEXT
,
UNITS
or
TARE
to change the selection. Press
PROGRAM/ENTER
to enter the selection.