Fairbanks NexWeigh - Manual (Page 21)

Section 4: Programming Configuration
04/14 21 51216 -- Rev. 6
4.5. PROGRAMMING STEPS
4.5.1. Setup Menu
1. Press and hold the PROGRAM/ENTER key or press S1 on the main PCB to
display SEtuP.
2. Press the PROGRAM/ENTER key to enter setup mode.
3. Press ZERO to set the desired Programming Menu.
The following section defines the program settings for the NexWeigh Instrument. The
default selections are underlined.
Programming Time Format:
This will determine whether the clock is
displayed and printed in 24 hour (military) or 12 hour (AM/PM) format. The display
will indicate either
12hour or 24hour . Press OVER/UNDER/NEXT or TARE
to change the selection. Press PROGRAM/ENTER to enter the selection.
SEt-ti:
Programming the Time: Time is set as HH.MM.SS and must be entered
in military format. The display will indicate SEt-ti followed by the current time with
the 10s digit of the hour flashing. Press UNITS to increase the digit or the 1 button
to decrease the digit. Press OVER/UNDER/NEXT to move the flashing digit right
or press TARE to move the flashing digit left. When the time is correct, press
PROGRAM/ENTER to accept the time and go to the next step.
SEt-dA:
Programming the date: Date is set as MM.DD.YY format. The display
will indicate SEt-dA followed by the current date with the 10s digit of the month
flashing. Press UNITS to increase the digit or the 1 button to decrease the digit.
Press OVER/UNDER/NEXT to move the flashing digit right or press TARE to
move the flashing digit left. When the date is correct, press PROGRAM/ENTER
to accept the date and go to the next step.
Id:
Scale ID: This step sets the scale ID from 1-32 . The display will indicate Id
XX where XX is the current ID setting. Press OVER/UNDER/NEXT or UNITS
to increase the setting, or press TARE to decrease the setting. When the correct ID
is displayed, press PROGRAM/ENTER to enter the value. The default Id is 01 .