Fairbanks NexWeigh - Manual (Page 23)

Section 4: Programming Configuration
04/14 23 51216 -- Rev. 6
4.5.1. Setup Menu, Continued
oPti:
Include time data with transmitted data: This determines whether or not to
include the time in the data string for Port 1. Display will indicate oPti followed by
the current selection of Y for yes to include, or n for no to exclude. Press
OVER/UNDER/NEXT , UNITS or TARE to change the selection. Press
PROGRAM/ENTER to enter the selection.
oPdA:
Include date data with transmitted data: This determines whether or not to
include the date in the data string for Port 1. Display will indicate oPdA followed by
the current selection of Y for yes to include, or n for no to exclude. Press
OVER/UNDER/NEXT , UNITS or TARE to change the selection. Press
PROGRAM/ENTER to enter the selection.
oPId:
Include ID data with transmitted data: This determines whether or not to
include the ID in the data string for Port 1. Display will indicate oPId followed by the
current selection of Y for yes to include, or N for no to exclude. Press
OVER/UNDER/NEXT , UNITS or TARE to change the selection. Press
PROGRAM/ENTER to enter the selection.
Port 2:
Programming Port 2: The display will indicate Port 2 , then OutPut, then
the current setting. Press OVER/UNDER/NEXT , UNITS or TARE to scroll
through the available choices. Press PROGRAM/ENTER to enter the correct
selection. Available selections are listed below.
OFF Function is not active.
PoLL Computer demand mode.
PoLLid Computer demand mode with ID
* Underline identifies the program default
NOTE: If B/G / NET is pressed after Port 2, the instrument will revert back to ID.