Fairbanks NexWeigh - Manual (Page 49)

Section 5: Serial I/O
04/14 49 51216 -- Rev. 6
5.4.8. NexWeigh Serial Commands and Definitions,
Continued
k) Recall Settings
Definition: Use recall current settings for Program, IO, and Checkweigh.
Recommended to not use if output mode is continous, as data will begin to be
overwritten with weight data.
Command: ‘rcs’ ‘category’
Options: I, P, C
Sample Command: "rcs P\r"
l) Change Active recipe
Definition: Used to change to a particular recipe setting. Simulates the pressing of
one of the recipe keys, only performed if that recipe is enabled.
Command: ‘rcp’ ‘recipe’
Options: 1,2,3,4,0
Sample Command: "rcp 1\r"
m) Autotare Weight
Definition: Used to Autotare the gross weight. Simulates the pressing of Auto tare
key. Only performed if motion criteria and Atare Enable met.
Command: ‘A’
Options: none
Sample Command: "A \r"
n) Set Balance Band
Definition: Used to set the balance (motion) band. Only valid settings allowed.
Command: ‘SBB’ ‘divisions’
Options: 0.5, 1, 3, 0
Sample Command: "SBB 0.5\r"
Sample Command: "SBB 3\r"
o) Set Display Rate
Definition: Used to set display update rate time in mSec. Only valid settings allowed.
Command: ‘SDR’ ‘mSec’
Options: 100, 200, 500, 800, 1000 etc.
Sample Command: "SDR 500\r"
Sample Command: "SDR 1000\r"