Luminex 100 IS Developer Workbench Guide Version 2.3 - Manual (Page 35)

x
MAP Technology
Create Template
PN 89-00002-00-084 Rev. B 29
automatically assigned to the next available well. Laboratory
personnel can select the starting location on the plate during
batch setup, but cannot change these commands. If you have
more than one command that involves the reservoir, those
actions must use the same solution.
For a complete list of template command descriptions see
Table 3 on page 20.
17. After you enter all the information into the template, click Save
to save the template, then click Close to exit.
Data Collection Only
Use the Data Collection Only template if you have your own data
post-processing program and want to obtain only fluorescent
intensity results.
You can not apply standards or controls when you use a template for
data collection only. Median results will be exported to an output file.
‹
To create a template for data collection only:
1. Click Create Template on the Developer Workbench toolbar.
The Template Setup wizard opens. See Figure 18.
2. Type the correct information in the Developing Company,
Created By, Template Name, Version No, and Description
boxes. The version number of the template is automatically
included in the template name that the lab personnel see when
they select the template to use with a kit.
3. Under Template Type, select Data Collection Only.
Note: You can return and edit
any unused templates using the
Edit Templates feature.