Create new product, Create new product dialog box buttons, Standards – Luminex 100 IS Developer Workbench Guide Version 2.3 User Manual
Page 15

x
MAP
Technology
Create New Product
PN 89-00002-00-084 Rev. B
9
Create New Product
Assay kits include products that are standards, controls, or standards
and controls. Once you create a product, it can be used in multiple
templates. However, you should create separate products specific for
use with each template.
You can not import different products into one template. Adding one
product and then another removes the first, replacing it with the
second.
Refer to the Glossary in the Luminex IS Software Manual for Version
2.3 for a list of definitions.
Create New Product
Dialog Box Buttons
There are five buttons on the upper right side of the Create New
Product dialog box.
Revert—Click to remove the information displayed in the Multiplex
Test Information and Test Reagents areas, but retain the Product
Information data. If you have not saved the information, the data
reverts to the original settings before you created the new product.
Save—Click to save the product after you enter all the applicable
data.
Close—Click to close the Create New Product dialog box. If you do
not save the product prior to closing, the software prompts you to
save it. Click Yes to save the new product.
Delete—Click to remove unsaved products and products that have
not been used in a template.
New—Click to add a new product to the existing list of products.
After clicking New, enter the appropriate information in the Create
New Product dialog box.
Standards
To create a standards only product:
1. Click Create New Product on the Developer Workbench
toolbar. The Create New Products dialog box opens. See
Figure 1.
Any currently defined products will be listed at the top of the
dialog box.