Clear-Com i-Series Panels - Manual (Page 75)

Clear-Com Communication Systems
I-Series Instruction Manual 6 - 1
INSTALLING AN
I-SERIES INTERCOM
PANEL
This chapter describes how to install an i-series intercom panel. It also
gives wiring diagrams for the panel’s rear-panel connectors. For
programming information, see the Eclipse Configuration System
Manual.
EQUIPMENT PLACEMENT
All i-series intercom panels require one rack unit of space (1 RU) in a
standard 19-inch (48.26 cm) rack.
Put all intercom panels at a comfortable operational height. Leave at
least 2 inches (5 cm) of clearance at the rear of the panel’s chassis to
allow for cable connectors and access to the rear-panel controls. For
proper ventilation, make sure ventilation openings are not blocked.
WARNING: To reduce the risk of fire or electric shock, do not expose
the unit to rain or moisture.
MAINS AC POWER
Each i-Series panel has an internal power supply, with a removable AC
power cord. The power supply is “universal,” operating over a voltage
range of 90 to 245 VAC and 50 to 60 Hz. The maximum dissipation is
40 W.
ADJUSTMENTS
No initial adjustments are required to set up the panels other than the
standard input level adjustment made through the Eclipse
Configuration System.
CONFIGURATION
Assign each panel’s name and other parameters by using the Eclipse
Configuration System. For instructions, see the Eclipse Configuration
System Manual.
6