Clear-Com i-Series Panels User Manual
Page 48
Clear-Com Communication Systems
I-Series Instruction Manual
3 - 8
Note: If PIN codes are set up in the Eclipse Configuration System
you must enter one of the four possible 4-digit PIN codes
before entering Local Key Assignment mode. The display
will ask for the PIN code at which time you must enter the
correct 4-digit code.
Figure 3-4: Assigning a Remote Source to a Listen Key
To assign a remote source to a key on your panel as a “listen”:
1. Press the “5” key on the numeric keypad to enter “pick list scroll”
mode.
A list of current panels and interfaces in the system that are
available to assign as “talk” keys (or as “talk-with-listen” keys) is
displayed starting in the leftmost key module’s display window.
2. Press the LISTEN key to display a list of current panels and
interfaces in the system that are available to assign as “listen” keys.
The list is sorted alphanumerically—with symbols first, then
numbers, then letters. You can jump to the desired alphabetical area
of the list by pressing the corresponding “letter” key on the keypad.
Press the “A” key to jump to the first label that begins with an “A,”
press the “B” key to jump to the first label that begins with a “B,” and
so on.
3. Scroll through the list of current available “listens” by rotating the
PROG/VOL knob.
You can also scroll one horizontal line at a time by pressing the
CLEAR key to scroll up the list and the ANSWR key to scroll down
the list.
4. Select the desired panel or interface when it is highlighted in the
display by pressing in and releasing the VOL/PROG knob.
5. Assign the selected remote panel or interface to a key on your panel
by either tapping or pressing the desired key.
The key glows green to indicate it is a “listen” and its new label
appears in the display.
1
2
3
Press the "5" key on
the numeric keypad.
A list of current sources in the system appears
in the leftmost display on the panel. Scroll through
the list. See the procedure for more information.
When the desired source appears in the display,
select it by pressing the VOL/PROG knob in, as if it were a key.
4
Assign the selected remote panel or interface to a key on your
panel by pressing the desired key. The key glows dim green. The
new label appears in the display.