Clear-Com i-Series Panels - Manual (Page 35)

Clear-Com Communication Systems
I-Series Instruction Manual 2 - 3
Figure 2-2 summarizes how to access these functions from the
LISTEN key. The sections that follow discuss the functions in detail.
Figure 2-2: Accessing Features from the Listen Key
Activating the “Monitor Mode” of a Talk-with-Listen
Key
Note: To avoid confusion, in this manual the LISTEN key on the
function-key module is referred to in all capital letters. On
your i-Series panel “LISTEN” is printed on this key in all
capital letters as well. Keys on your panel programmed to
“listen” are referred to in this manual in lower-case letters,
as in “the listen key glows bright green.”
The i-Series panel “monitor mode” allows you to momentarily change
the status of a key from listen-only to talk-with-listen. By pressing and
holding the listen-only key, you momentarily change it to a
talk-with-listen key.
1
2
To activate the "listen" function of a "talk-with-listen" key, press the LISTEN key less than five seconds ("tap" the key)
and then tap the desired "talk-with-listen" key. The LISTEN key illuminates bright green.
To send a call signal, press the LISTEN key for between 1 and 5 seconds and then press the key of the destination that you
want to send the call signal to. The LISTEN key illuminates bright red.
To release a remote telephone line, press the LISTEN key for 5 seconds and continue to hold while you press the desired
telephone interface key. The LISTEN key turns dim red and flashes on and off.
3
MONITOR MODE
CALL SIGNAL
RELEASE A REMOTE TELEPHONE LINE