Clear-Com i-Series Panels - Manual (Page 62)

Clear-Com Communication Systems
I-Series Instruction Manual
4 - 6
1. Select the “Studio Announce” option in the Eclipse Configuration
System.
2. Connect a logic device (such as a foot switch, a panel-mounted
switch, or the logic output of another device) to the i-Series panel’s
GPI connector.
3. Switch on the logic device to activate the panel’s studio announce.
Holding down the switch activates a talk path to the studio announce
output.
Note that the logic switch, like studio announce itself, cannot be
latched. It functions momentarily only.
Speaker Off
The “Speaker Off” function allows you to set up an external logic
device, such as a panel-mounted switch, a foot switch, or the logic
output of some other device, to shut off the panel’s loudspeaker.
To use a logic device to shut off the panel’s loudspeaker:
1. Select the “Speaker Off” option in the Eclipse Configuration System.
2. Connect a logic device (such as a foot switch, a panel-mounted
switch, or the logic output of another device) to the i-Series panel’s
GPI connector.
3. Switch on the logic device to shut off the panel’s loudspeaker.
PTT: Activate All Talk Keys
The PTT: Activate All Talk Keys function allows you to set up an
external logic device, such as a panel-mounted switch, a foot switch,
or the logic output of some other device, to activate all latched keys at
your panel. When the logic device is not activated, you will not be able
to talk from any latched key at your panel.
For example, some headsets are equipped with a push-to-talk switch
on their headset cords. The push-to-talk switch can be wired to
operate as a logic device. When an intercom operator wants to talk to
any destination with a latched key on his panel, he will only be able to
do so if he first pushes the push-to-talk switch on the headset cord.
To use a logic device to activate all latched talk keys:
1. Select the “PTT: Activate All Talk Keys” option in the Eclipse
Configuration System.
2. Attach a logic device (such as a foot switch, panel-mounted switch,
a push-to-talk headset, and so on) to the i-Series panel’s GPI
connector.
3. Switch on the logic device to activate all latched keys at your panel.
The logic device will activate keys latched both before and after you
enabled this function in the Eclipse Configuration System.
Note that the latched keys at your panel may appear to be active, since
their talk lights will illuminate, but they actually only activate when you
switch on the connected logic device. Any controls (relays, etc.)
You can install a logic device
to activate a key assigned to
a 2-way radio.