Clear-Com i-Series Panels - Manual (Page 24)

Clear-Com Communication Systems
I-Series Instruction Manual
1 - 1 4
When you release the key, it will resume flashing at the radio-receiver
active rate.
The radio-receiver active light requires that the radio receiver is
connected via a FOR-22 interface. The radio receiver active light
feature must be enabled in the Eclipse Configuration System under the
Advanced Settings and Tallies options for the FOR-22 interface. For
more information, see the Eclipse Configuration System Manual.
Panel Connected Light
When the Station Connected Tally option is selected in the Eclipse
Configuration System software (under Advanced Settings > Global
Settings), whenever a destination panel is connected to the Matrix
frame its assigned key on your panel will flash red once per second.
This option is primarily used when a destination panel is connected to
the Matrix frame via a long-line link that might be active only at certain
times.
The Station Connected Tally is a feature that must be set up in the
Eclipse Configuration System program. For more information, see the
Eclipse Configuration System Manual.
Audio-Presence Light
If you assign a source to your panel as a listen-only key, the key will
flash green once per second if there is audio present at the source.
The audio-presence light is a feature that must be set up in the Eclipse
Configuration System. For more information, see the Eclipse
Configuration System Manual.
Incompatible Firmware Light
If the firmware on your panel is incompatible with the matrix, all lights
on the panel will blink dim red once per second, and if displays are
present, they will read: “No connection to Eclipse”.
SUMMARY OF KEY MODULE LIGHTS
Table 1-2 summarizes the meaning of key colors and blink rates on a
key module.