Clear-Com i-Series Panels - Manual (Page 47)

Clear-Com Communication Systems
I-Series Instruction Manual 3 - 7
Figure 3-3: Assigning a Remote Destination to a Talk or Talk-with-Lis-
ten Key
To assign a remote destination to a key on your panel as a “talk”
or “talk-with-listen”:
1. Press the “5” key on the numeric keypad to enter “pick list scroll”
mode.
• A list of current panels and interfaces in the system that are
available to assign as “talk” keys (or as “talk-with-listen” keys) is
displayed starting in leftmost key module’s display window.
• The lists are sorted alphanumerically—with symbols first, then
numbers, then letters. You can jump to the desired alphabetical
area of the list by pressing the corresponding “letter” key on the
keypad. Press the “A” key to jump to the first label that begins with
an “A,” press the “B” key to jump to the first label that begins with
a “B,” and so on.
2. Scroll through the list of current available “talks” and “listens” by
rotating the PROG/VOL knob.
You can also scroll one horizontal line at a time by pressing the
CLEAR key to scroll up the list and the ANSWR key to scroll down
the list.
3. Select the desired panel or interface when it is highlighted in the
display by pressing in and releasing the VOL/PROG knob.
4. Assign the selected remote panel or interface to a key on your panel
by either tapping or pressing the desired key.
• Tap a key for less than 1/2 of a second to assign it as a talk-only.
• Press a key for more than 1/2 of a second to assign it as a
talk-with-listen key.
5. After you have completed assigning keys, exit “pick list scroll” mode
by pressing the ESCAPE key (labeled “*RED”). To exit the current
menu only, and return to the previous menu, press the
FUNCTION-CLEAR key (labeled “0 CLR”).
1
2 3
Press the "5" key on
the numeric keypad.
A list of current destinations in the system appears
in the leftmost display on the panel. Scroll through
the list. See the procedure for more information. When the desired destination appears in the display,
select it by pressing the VOL/PROG knob in, as if it were a key.
4 Assign the selected remote panel or interface to a key on your
panel by tapping the desired key for less than 1/2 second to assign it
as a "talk" or for more than 1/2 second to assign it as a "talk-with-listen."