B&K Precision 2552-2559 - Manual - Manual (Page 96)

96
• The New File menu options are the same as the New Folder
menu. The InputChar option button adds the selected character to
the cursor position in Name field.
• Move the cursor position in the name field using the “→” and
“←” option buttons.
• Turn the “Universal” knob to move through character selections.
When the desired character is highlighted, press the “Universal”
knob or press the “InputChar” option button to add it to the
specific position in the Name field.
• Additional selections for BackSpace, DeleteCharacter, and
CleanName are available for convenience and are also accessible
using the “Universal” knob in the same manner.
• Press the “Confirm” option button (when you have the Name field
completed as desired) to save the file onto the memory device.
After the “Confirm” option button is pressed, a “Data Store
Success!” message is briefly shown and the new folder or file will
be listed under your USB flash drive.
Save/Recall Setup
• Save Setups to Device: The complete setup is stored in
nonvolatile memory. When you recall the setup, the oscilloscope
will be in the mode from which the setup was saved.
The oscilloscope saves the current setup if you wait three seconds
after the last change before you power off the oscilloscope. The
oscilloscope recalls this setup the next time you apply power.
Table 42 - Save Setup to Device Function Menu
Option Setting Description
Type Setups Menu for the Storage/Recall setting
in the oscilloscope
Save to Device Save setup to the oscilloscope’s
internal memory.
Setup No.1 to No.20 Press the “Setup” option button or
turn the “universal” knob to select
storage location.
Save Save to the selected storage location.
Recall Recall from the storage location
indicated by “Setup”.