B&K Precision 2552-2559 - Manual - Manual (Page 61)

61
Figure 35 - Slope Trigger Menu 2
Operating Instructions:
Follow next steps if you select “Slope trigger”:
1. Input a signal to one of the channel inputs.
2. Press the “AUTO” button.
free-run in the absence of a valid
trigger. This mode allows an
untriggered, scanning waveform at 100
ms/div or slower time base setting.
Normal
Use this mode when you want to see
only valid triggered waveforms. When
you use this mode, the oscilloscope
does not display a waveform until after
the first trigger.
Single
When you want the oscilloscope to
acquire a single waveform, press the
“SINGLE” button.
Set up Enter the “Trigger setup menu”
Next Page Page 2/2
Return to the first page of slope trigger
menu.