B&K Precision 2552-2559 - Manual - Manual (Page 141)

141
Chapter 5 Message Prompts
and Troubleshooting
Message Prompts
• Trig level at limit! : Prompts you that the trigger Level is at a
limit when you turn the Trig level knob.
• Horizon position at limit! : Prompts you that the horizontal
position is at a limit when you turn the horizontal position knob.
• Volts/Div at limit! : Prompts you that the vertical voltage has
already reached the Min 2mV/div or the Max 5V/div.
• Volts position at limit! : The system would display this
information when the vertical position is at a limit.
• Time/Div at limit! : Prompts that the Time/Div is at full range
while turning the horizontal scale knob.
• Holdoff time at limit! : Prompts you that the holdoff time setting
has reached max or min value.
• Function isn’t useable! : Under several special modes, some
functions could not be running.
• No signal! : The system would display this information when the
signal could not match the auto set condition while using the auto
set function.
• Adjust at limit! : Prompts that the pulse width setting has reached
min 20.0 ns or max 10.0 s.
• Location Empty! : If you have no stored waveforms or setups at
specified location, the screen will display this information when
you press the “Recall” button on this location.
• USB Flash Drive Plug In! : This information will appear when
you insert the USB Flash Drive to the USB Host port.
• USB Flash Drive Pull Out! : This information will appear when
you pull out the USB Flash Drive from the USB Host port.
• Store Data Success! : Saving setup data, waveform data or picture
data to the internal memory of the oscilloscope or USB flash was
successful.