Alpha Technologies AlphaNet IDH4 for XM3-HP Series - Technical Manual - Manual (Page 64)

64 746-257-B5-001, Rev. A1 (11/2013)
Fig. 7-8, System Interconnection Diagram
7.7 Front Panel Connections
Connections
Connections with more
than one power supply
Battery Sense Wire Harness
Refer to Section 8.0 Battery Sense Wire
Kits for part numbers and wiring options.
C
O M
S Y
S
C
O M
S Y
S
Generator (ECM)
ECM to SCM Interface
(Alpha P/N 704-709-20)
B
C
A A
B
Comm Port
System Port
Battery Sense Connections
B
C
A
A
Environmental connection
Ethernet connection
RF connection
7.0 Installation, continued
Connect the RF drop according to the diagram below. The RF drop must have a properly installed ground
block in the power supply enclosure. Recommended downstream RF level is 0 dBmV. Connect any other
front panel connections at this time (e.g. battery strings, tamper switch).
Install a grounded surge suppressor (Alpha P/N 162-028-10 or equivalent) to protect
equipment from overvoltage.
CAUTION!
RF Cable
to Headend
Grounded Surge Protector
(See Caution Above)
Fig. 7-7, Connecting the RF Drop
7.6 Connecting the RF Drop
Linked CableUPS
Serial Interface Cards
IDH4 Series in
Primary XM3-HP
AlphaBus Cable
(Alpha P/N 875-190-20 for 6',
-21 for 9', -22 for 18', -23 for 35')