Alpha Technologies AlphaNet IDH4 for XM3-HP Series - Technical Manual - Manual (Page 24)

24 746-257-B5-001, Rev. A1 (11/2013)
4.0 Web Interface, continued
4.3 Navigating the Web Page, continued
4.3.1 Web Interface Security Levels
Within the IDH4 Series transponder are two levels of function-specific security. General operation-
related functions are set at Level 1 and configuration-related functions are set at Level 2.
Default User Name and Security Passwords are shown in the figure below.
Fig. 4-8, IDH4 Series Transponder Security Levels
IDH4 Series Web Page Security
OID Function Value
1.3.6.1.4.1.4413.2.2.2.1.1.3.3.0 Level 1 User Name Alpha
1.3.6.1.4.1.4413.2.2.2.1.1.3.4.0 Level 1 Security Password AlphaGet
1.3.6.1.4.1.4413.2.2.2.1.1.3.1.0 Level 2 User Name Alpha
1.3.6.1.4.1.4413.2.2.2.1.1.3.2.0 Level 2 Security Password AlphaSet
Web Page Function Security Level
General
System Name, System Contact, System Location,
Common Logical ID
1
Power Supply Self Test 1
Generator Self Test 1
Advanced Communications
Reset Transponder 1
Provisioning Mode - Single IP or Dual IP 2
Configure Static IP Address 2
Configure Proprietary Trap Addresses 2
Power Supply Self Test 1
Advanced Power Supply Configure/Save 2
Reset Output 1/2 2
Advanced Generator
Generator Self Test 1
Reset Latched Alarms 1
Modem Log [Event Log] Reset Log 1
Advanced I/O
Tamper Switch Polarity 1
Enclosure Heater/Cooler Installed 1
Apps Overview Configure/Save 2
Battery Management Configure/Save 2