beautypg.com

0 installation, continued – Alpha Technologies AlphaNet IDH4 for XM3-HP Series - Technical Manual User Manual

Page 60

background image

60

746-257-B5-001, Rev. A1 (11/2013)

7.2

Module Installation Procedure in XM3-HP Power Supplies, continued

7. Fasten the IDH4 Series to the Inverter Module by tightening the two captive screws. It is

recommended that the screws be tightened alternately, a few turns at a time so the transponder

aligns in parallel to the Inverter Module.

8. Reinstall the Inverter Module and tighten the two thumbscrews. Make front panel connections

(tamper, temperature sensor, battery sense, RF etc.).

9. If not yet done, record the cable modem MAC address from the front of the unit and report it to the

network manager for network provisioning.

6. Line up the 18-pin mating connectors on the IDH4 Series and the XM3-HP Inverter Module. Gently

push the IDH4 Series into the Inverter Module until the 18 pin mating connector is properly seated.

Fig. 7-3, Connecting the Transponder to the Inverter Module

Fig. 7-2, The 18-pin Connector

7.0 Installation, continued