Extron Electronics PoleVault Digital Switcher Systems PVS 405D - Manual (Page 33)

Stage 2:
Mounting the PVT
Wallplate and the
MediaLink Controller
Stage 2 Involves installing and cabling the devices shown below.
NOTE: The installation must conform to national and local electrical codes and UL requirements. See the
device user guide for details.
PVT SW HDMI RGB D AV Source Input Wallplate
•
Where it goes: Installs in a wall near input source location.
• What it does: Transmits an input source HDMI or RGB video and audio signals to the switcher.
NOTES:
• The PVT SW HDMI RGB D is a 2-gang wallplate.
• The PoleVault Digital System incorporate EDID Minder. This allows the transmitter to communicate the
appropriate EDID information to the source, ensuring correct video output resolution.
• The EDID settings on the PVT wallplates are set during switcher configuration. See the PVS 405D
PoleVault Digital Switcher User Guide (available at
www.extron.com ),or the PCS Help file for setup and
operating details.
VGA IN
AUDIO
IN OUT
LOCAL OUT
AUDIO IN
HDMI IN
IR OUT
G
S
PVT SW HDMI RGB D
Decora
Faceplate
Mounting
Screws (4)
Audio Input
Connector
VGA IN
AUDIO
IN OUT
LOCAL OUT
AUDIO IN
HDMI IN
IR OUT
G
S IR Output
Audio and
HDMI input
Connectors
Signal/Power
Status LED
VGA Input
Connector
Local Monitor
Output
Audio Output
Connector
PVT Output Port
(at Rear)
L R - A
UDIO IN
PVT SW HDMI RGB
D
SIG LINK PVT OUT
Audio Input
Connector (at Rear)
PoleVault Digital Systems • Installation — Stage 2 (Wallplates and MLC) 27