GE Industrial Solutions Entellisys System User Manual - Manual (Page 210)

Alarms and events 210
A
Caution: Firmware Download
Failed for [CPU A/B/Messngr].
Unable to Enable Flash Pgm
Mode. Replace CPU Contact GE Service for CPU replacement Contact GE Post Sales Service (see How to
contact us on page 2 ).
Caution: Firmware Download
Failed for [CPU A/B/Messngr].
Cannot Erase Firmware.Replace
CPU Contact GE Service for CPU replacement Contact GE Post Sales Service (see How to
contact us on page 2 ).
Firmware Downloaded OK To
[CPU A/B/Messngr] Logged upon successful completion of a CPU
firmware upgrade
Firmware Download Failed for
[CPU A/B/Messngr] Contact GE Service for CPU replacement Contact GE Post Sales Service (see How to
contact us on page 2 ).
Caution: Firmware Download to
[CPU A/B/Messngr] Cannot be
Verified Contact GE Service for CPU replacement Contact GE Post Sales Service (see How to
contact us on page 2 ).
Attention: Flash File Error in [CPU
A/B/Messngr]. Unable to disable
Flash Pgm Mode.Replace CPU Contact GE Service for CPU replacement Contact GE Post Sales Service (see How to
contact us on page 2 ).
Caution: Firmware Dwnld Failed.
Err Reading Messnger Status for
[Breaker(s)] An error was detected in confirming the
status of a Messenger prior to upgrading its
firmware. Contact GE Post Sales Service (see How to
contact us on page 2 ).
Caution: Firmware Dwnld Failed.
Err Reading Messnger Status
during Switch for [Breaker(s)] An error was detected in confirming the
status of a Messenger after its firmware has
been updated. Contact GE Post Sales Service (see How to
contact us on page 2 ).
Caution: Settings Update
Failed.Retry will Occur in 30
minutes An attempt to update the local settings file
was unsuccessful and a retry will be
attempted in the specified time period. If this error is repeated, Contact GE Post Sales
Service (see
How to contact us on page 2 ).
Caution: IP Error X For IP
Address [n.n.n.n] The HMI encountered an error in establishing
a TFTP session with a CPU.
Note: FTP Error X An error has occurred during FTP protocol
transfer with a CPU. Contact GE Service. Contact GE Post Sales Service (see How to
contact us on page 2 ).
Note: TFTP Error X An error has occurred during TFTP protocol
transfer with a CPU. Contact GE Service. Contact GE Post Sales Service (see How to
contact us on page 2 ).
HMI File [Name] Published OK The HMI successfully updated the specified
file in the CPU
HMI File [Name] Retrieved OK The HMI successfully retrieved the specified
file from the CPU
Caution: Error Publishing File
[Name]. Retry An error has occurred attempting to updated
the specified file and a retry will be
attempted
Table A-2 Sequence of events description and troubleshooting guide
Event Description Notes and Troubleshooting tips