GE Industrial Solutions Entellisys System User Manual User Manual
System user manual
Table of contents
Document Outline
- Contents
- System architecture
- 1.1 Description of operation
- 1.2 Switchgear installations
- 1.3 System components
- 1.3.1 EntelliGuard circuit breaker
- 1.3.2 Current transformers
- 1.3.3 Potential transformers
- 1.3.4 EntelliGuard Messenger
- 1.3.5 Compartment ID button
- 1.3.6 Messenger communications network
- 1.3.7 Messenger switch
- 1.3.8 CPU
- 1.3.9 Synch clock
- 1.3.10 Digital I/O
- 1.3.11 System interface Ethernet communication network
- 1.3.12 System interface Ethernet switch
- 1.3.13 Touchscreen HMI
- 1.3.14 Remote HMI
- 1.3.15 VPN firewall device
- 1.3.16 Control power
- 1.3.17 UPS
- 1.3.18 UPS to HMI connection
- 1.3.19 RS-232 to RS-485 converter
- 1.3.20 Entellisys System Test Kit
- 1.3.21 Clamp circuit
- Specifications
- Basic control
- Metering
- Single point functions
- 5.1 Overcurrent protection
- 5.2 Single Point Relay protection
- 5.3 Synch Check relay
- Zones, buses, and topologies
- Multipoint functions
- 7.1 Bus Differential Relay
- 7.2 Multi-Source Ground-Fault Relay
- 7.3 PT Throw-Over
- 7.4 Zone Selective Interlock
- Reduced Let-Thru Mode
- Sequence of events, fault reports, and waveform capture records
- Digital I/O
- 10.1 Discrete inputs/outputs
- 10.1.1 Hardware
- 10.1.2 Software
- 10.1.3 Setup
- 10.1.3.1 Wiring
- 10.1.3.2 I/O points direction
- 10.1.3.3 Input configuration
- 10.1.3.4 Output configuration
- 10.1.3.5 Operation
- 10.1.3.6 Contact input states
- 10.1.3.7 Contact output states
- 10.1.3.8 Test mode
- 10.1.3.9 Input test mode
- 10.1.3.10 Output test mode
- 10.1.3.11 Events
- 10.1.3.12 Configuration events
- 10.1.3.13 Confirmation events
- 10.1.3.14 Operation events
- 10.1.4 Troubleshooting
- 10.1 Discrete inputs/outputs
- FlexLogic™
- 11.1 Introduction to FlexLogic
- 11.2 FlexLogic rules
- 11.3 FlexLogic evaluation
- 11.4 FlexLogic Equation Editor
- 11.5 FlexLogic equation viewer
- 11.6 FlexLogic timers
- 11.7 FlexLogic virtual inputs
- 11.8 FlexLogic virtual outputs
- 11.9 FlexLogic circuit breaker commands
- 11.10 FlexLogic control alarms
- 11.11 Load FlexLogic equation
- 11.12 Save FlexLogic equation
- 11.13 FlexLogic example
- 11.14 FlexLogic redundancy
- Preventive maintenance
- Alarms
- System health
- Control power and UPS configuration
- Alarms and events
- Index